Hunablinds 1.6.8

Reviews

4 ★, on 2019-07-01
After a dodgy start I am now able to use the app without any further problems (Android). Using the app to open at sunrise and close at sunset. There are also timer settings which I use to close halfway in morning and open fully mid afternoon. You can also set up your own positions (2 thirds open or 1 third etc and save them). It also works as a go between to set up both the sun sensor and the wall switch, both of which were working in a matter of seconds. It would 5* if it could work with IFTTT.

1 ★, on 2019-08-06
I have 5 blinds within max 15 m. range. When I start the app it can take more than 30 sec. to have them all connected. This is way to long you have to wait before being able to operate them all at once in scenarios. Sometimes it takes so long that the phone screen times out and you have to start all over, because the app has to reconnect everytime the app gets fokus. It's almost useless.

1 ★, on 2019-10-13
One of my installed blinds required an update. I updated it and the app hung/crashed mid-update. I can no longer connect to the blind and trying to remove the blind and add it again doesn't work. I now have a useless blind which doesn't work. Can these things be factory reset or is it just dead hardware now?

4 ★, on 2019-01-27
Mostly there, some things missing. There's no way to skip past the scan qr code page which means if you've already done this step you can't follow the final three installation steps. I had to guess what to do.

2 ★, on 2019-01-16
Extremely shonky app. I use the app direct to blind. Never works for more than a couple of weeks then you have to re-set. Painful.

1 ★, on 2018-10-25
Very difficult to set up controls and no smart function enable.to connect to smart home. A step backwards...