Europrog 2 27.03.2024

Reviews

1 ★, on 2018-09-30
Awful app. Europrog 1 is a hair better. Is there any other app compatible with these lidl termostats?

1 ★, on 2018-01-14
Either the unit from lidl is useless, or the program. You can not save your settings and it keeps asking to save a new pin every time it starts. 30% savings, as lidle claims is thus gone. I will return the unit. Why, does Europrog not reply in English? International market players should be able to do that. - very poor!!

2 ★, on 2018-02-27
It's nice that it's programmable and is able to keep a breathable temperature in the night, but the app is terrible. I really hope there is an API so that I can write my own app that does something that I expect. No idea what the detected temperature is so I can correctly set the offset, and any kind of analysis would also be nice. And the holiday mode set at 8 degrees (the minimum, since it's freezing outside) gives me 16 degrees after 1 day. Trying my luck with off on holiday, but I suspect it does not work at all.

3 ★, on 2017-11-01
Good once you get used to it. Was a bit tricky when trying to add 3 devices. Had to take battery out the other two. Discovered later that it is possible to change the blutooth names. Range seems to be very good. Downsides are the time it takes to connect and the battery on one device is shown at 0%.

1 ★, on 2017-12-06
The measured zone/room temperature - one of the most important data - is not shown at all. No overview of all zones/rooms, only data of one thermostat can be shown at the same time. Skipping to next thermostat takes too much time. No temperature logging, no graphics like temp vs. time. More issues 2017 December 03: Sometimes when updating, no error message tells the user that the data were not successfully sent to the unit. Full names of stored profiles can not be seen before loading. If time interval is defined from 00:00 to 24:00, the software interprets it as off instead of on all the time. Is there an alternate software or open project?

2 ★, on 2018-03-19
App gets better, still switching between rooms is too long. Second device in same virtual room doesnt always respond to temp change. Pairing is easier as now one can only pair to nearest one, which makes it easier to add 5 new. Why not show actual temperature readout from all rooms? Know it will consume battery but its trendy to show graphs (optional).If you leave one phone with teamviewer installed you will be able to control temperature from out of home. 2017/Sep app doesnt connect after update, Devices are unsecure as are loosing pin after battery change.